The plate with Angle polishing machine inclination is larger than the case will make the paint hot fast, and the friction of the side of the disc is increased, easy to grind bad car paint, will also make the polishing plate contact paint area will become narrow.
The basic method of grinding operation of mobile polishing machine is to grind the paint surface evenly as the basis. For this reason, we need to find a way to "control the pressure of polishing to a certain extent". Press pressure - based on the weight of the polishing machine itself in the plane of the polishing machine's own weight as a basis, do not need to use too much pressure, even in the side of the polishing operation, but also need to use the same pressure as the plane. Do not increase or decrease the pressure, so that it is not easy to produce some parts of the uneven pressure cast serious parts of the light and the resulting aperture or scratch is not removed. Angle of disc to polish - Avoid adding pressure locally Polishing is based on the shape of the disc using pressure. Excessive polishing can cause "uneven grinding surface", "polishing boundaries", "polishing scars" and so on. Grinding range a grinding range is due to the shape and size of the car body is not the same, so it can be controlled in a certain range, with the width of the shoulder as the boundary, if the use of too wide to rely on the use of uneven arm force, human physical strength will be difficult to support, but also cause uneven polishing surface. The moving speed polishing machine and the grinding agent on the disc form a more suitable speed when grinding, if the speed is too fast, can not control the pressure, but also make the cutting amount is not up to, there will be "friction uneven". The above treatment method is the basic method, but the car disk surface is presented with a complex shape, so the following operation method: polishing is not only one direction, but also to the longitudinal direction, transverse direction, in order not to avoid friction uneven. The AMOUNT OF MOVEMENT OF THE POLISH - ALLOWING THE OVERLAPPING SURFACES TO LEAVE MARKS ON THE PAINT IS ABOUT 1/3 TO 1/4 OF THE AREA OF THE OVERLAPPING SURFACES AT A TIME.